This course is not about creating soft processors, it is just an introduction on how to configure (trival parts of) an existing soft-processor (nios2) without explaining some crucial parts of it.

If your intention is to learn how to setup a nios2 soft-processor you can learn about it just by reading the freely available nios2 documentation from altera. Don't waste your time here.

If you want to learn about soft-processor architectures this course is absolutely not for you.

I​f your intention is to get extra 3 points for your university degree, then this series of 4 courses can be useful, but keep in mind that you'll learn almost nothing.

As expected, this 4 courses specialization is no more and no less than a w​aste of time and money. Not worth it.

Loved the course!

I'm trying everything on my new DE10-Lite.

There's a steep learning curve on the first two weeks, but it all comes together mid week 2.

I had a lot of issues but all of them got solved in the discussion forum.

I feel I did another small step towards mastering designing with fpga. Thank you!

I learned a lot about modelsim that I was really needed.

This course brought a great deal of insight in the designing of:

1. NIOS-II processor

2. Integration of pre-existing IP-cores with your design

3. The simulation, debugging and verification of hardware

The core concepts (I have taken from this course) are gemstone and will be guiding star for my future "Embedded system Designing endeavor".

Must-take Course for Hardware Engineeer. This course provides new concept about NIOS II 32-bit RISC Architecture and How HDL Simulation work

Well prepared lessons(videos). Concise and complete.

Very helpful, Thnaks for all

Excellent

The course bring good theoric bases to IPCores but leaves short informacion about the Qsys use, memory map and others things that are necesary for system integration.

I was hoping to get more lecture material on writing testbench code.

The examples do not compile easily in quartus 20.1. Coding examples need to include more about software and building something that actually works. Course needs to be updated.

A lot of just slide reading and listing, last week of the course is cool because you understand a bit better the simulation

No hands on exercises, we "learn" how to make test benches without practising...

In the series of four courses under FPGA Embedded systems, I found only the introductory course helpful. Course 2 and 3 have been cursory at best. There's no proper explanation on how to work on the DE Lite boards, the professors are just reading out of the slides without explaining anything. There are no responses to the queries. Don't waste your time doing these courses. I'm only sticing to it because I paid the money. It's an absolute waste of time.

By far the weakest part of this specialization. Avoid unless you're working to complete the specialization FPGA Design for Embedded Systems.

I​ didn't uderstand all course videos, I reply all videos as much as I can, and still I can not have a clear understanding